User`s manual

Unity 4650 User’s Manual
800034-01 Rev. A 70 wegener.com
TEST
group value
group:Mnemonic for a test group: Either RF, AV, DTMF, or REL.
value:Parametric value which has meaning depending on the test group
selected.
Command to activate Installation Test Modes. A Local Control Command
(available from the terminal regardless of "Local Control Enable/Disable"
commands from the network).
If group is RF, the legal values are 1, 2, 3, 4, and OFF. Entering numbers for
value cause the IRD to report the RF level (not locked to carrier) at that RF
Feed Port every few seconds. Entering OFF stops the measurement.
If group is AV, the legal values are ON and OFF. If ON, a test pattern is acti-
vated on the video output and test tones activated on the audio output, the same
as the generic TESTMODE command.
If group is DTMF, the legal values are ON and OFF. If ON, the command
behaves like the DTMFVOL command entered with no parameters.
If group is REL, the legal values are ON and OFF. If ON, both user cue relays
are alternately energized and de-energized.
TESTOFF
Command stops all volatile test functions as if unit were reset. A Local Control
Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
UNMUTE
[source][source][source][...]
source: Same as the MUTE command.
Identical to MUTE except specified services are unmuted.
VER
Displays the boot-up Welcome banner and the versions of hardware and soft-
ware components within the IRD. Should include the unit serial number, model
number, and customer ID. A Local Control Command (available from the ter-
minal regardless of "Local Control Enable/Disable" commands from the net-
work).