User`s manual

Unity 4650 User’s Manual

800034-01 Rev. A 54 wegener.com

GLPHASE

phase

phase: Integer between -180 and +180 inclusive.

Command to adjust the subcarrier phase of genlocked composite video output,

relative to the reference. The offset in degrees is set by the phase parameter,

with the actual register values set for the nearest degrees of adjustment reso-

lution. Positive settings of phase will force the video subcarrier phase to lead

the genlock reference. For example, a setting of -10 directs the unit to use -9.9°

of backward offset. Entering the command without the phase parameter causes

the unit to report the current SC phase offset setting.

[command]

command: Any of the terminal command names (PC, R, PORT, etc.).

If an ‘H’ or any invalid command beginning with an 'H' is entered and com-

mand is omitted, the whole help screen will be displayed, consisting of a list of

all currently available commands and a brief description of each listing. If an

‘H’ or any invalid command beginning with an 'H' is entered and command is a

valid User Command Name, then detailed help for command is displayed. A

Local Control Command (available from the terminal regardless of "Local

Control Enable/Disable" commands from the network).

INDPERS

indication time

indication:“A” (for “Alarm”) or “W” (for “Warning”).

time:Time in seconds.

Command to set the minimum indication-time persistence for either Alarms or

Warnings, per the value of indication, for the time period given by time. Enter-

ing command without parameters shows the current settings. A Local Control

Command (available from the terminal regardless of "Local Control Enable/

Disable" commands from the network).

IPCONFIG

Command requests report of all current IP parameters (IP address, Gateway

address, subnet mask) and assignment mode (static or DHCP). A Local Con-

trol Command (available from the terminal regardless of "Local Control

Enable/Disable" commands from the network).