Specifications

Supported Devices
Pro Broadband, Inc. (PBI)
60
Certain parameters may be passed to the plug-in, as follows:
Multicast IP address Text/Signal multicastIPAddress ethernet output multicast IP address
TS packets per UDP Text/Signal
tsPacketPerUDP ethernet output TS packets per UDP
TTL Text/Signal
ttl ethernet output ttl
External board netmask Text/Signal
sourceNetmask External board netmask
External board gateway Text/Signal
sourceGateway External board gateway
External board mac Text/Signal
sourceMac External board mac
Multicast port Text/Signal
multiUDPPort Multicast port
Protocol Text/Signal
protocol Protocol : udp or trp
Type service Text/Signal
typeService normal, min delay, max throughput, max reliability, min
monetary cost
Source StatusText/Si
gnal
source Text can be asi, tuner, ds3, CI. Status is NORMAL if
source value correspond to the parameter "inputType".
If source is unlnown or does not match, status is set to
CRITICAL.
Mode Text/Signal
mode DVB, IPTV
Max Channel Text/Signal maxChannel when mode is IPTV, hardware sustain max channel
Current MaxChannel Text/Signal
curMaxChannel when mode is IPTV, device can output channel number
most currently
Channel Input Text/Signal
channelInput when mode is IPTV, input channel number currently
MulticastValues Text/Signal
multicastValues when mode is IPTV, the value of multicast
Gateway Mac address Text/Signal
gatewayMac gateway mac address
HighTargetMac Text/Signal
highTargetMac when mode is IPTV, it denote all multicast channel's
target mac, only save high 32bit, one channel occupy 4
bytes
LowTargetMac Text/Signal
lowTargetMac when mode is IPTV, it denote all multicast channel's
target mac, only save target mac's low 16bit, one
channel occupy 4 bytes, latter 2 bytes is effective
TargetMac4Dvb Text/Signal
targetMac4Dvb when mode is DVB, the target mac address
Parameter Description
AlarmPath Used to set the Alarm prefix.
Default value:
PBI
Could be replaced by IRD so as to have legacy plug-ins tree look-like.
pollInterval Poller interval in seconds. Overwrite the default interval of 20 seconds.
Health monitoring alarms ( Continued)
Alarm name Type MIB point Further details