Specifications

Supported Devices
Motorola
52
Certain parameters may be passed to the plug-in, as follows:
--- Signal status alarms ---
Acquisition State Status/Text acquisitionState Fast poller Displays the acquisition state for the
active signal
Authorization State Status/Text
authorizationState Fast poller Displays the authorization state for
viewing the current signal (31 states)
Encryption Mode Status/Text
encryptionMode Fast poller Displays the encryption mode of the
current signal (5 modes)
Signal Quality Status/Text
signalQuality Fast poller Displays the RF quality level of the
current signal, the threshold is currently
set to 30 which can also be passed as a
parameter
Signal Power Status/Text
signalPower Fast poller Displays the RF power level of the
current signal, the threshold is currently
set to -45 which can also be passed as a
parameter
Signal to Noise Ratio Status/Text
ebNo Fast poller Displays the signal to noise ratio of the
current signal, the threshold is currently
set to 10 which can also be passed as a
parameter
Parameter Description
pollInterval Fast poller interval in seconds. Overwrite the default interval of 20 seconds.
retries If an SNMP request times out, this defines the number of retries to be performed.
Default is 1.
timeout Delay in seconds before declaring a timeout in the current SNMP request.
uniqueID An extra identifier to be assigned to the plug-in to differentiate its alarms from the other
plug-in of the same type. The
uniqueID should be part of the URI.
readCommunity SNMP read community string. Use for SNMP polling.
sqTrsh By setting this parameter we can define the Signal Quality threshold value.
spTrsh By setting this parameter we can define the Signal Power threshold value.
snrTrsh By setting this parameter we can define the Signal to Noise Ratio threshold value.
trshLevelFla By setting this parameter we can define the threshold level for the available flash (a
number from 0 to 1).
trshLevelMem By setting this parameter we can define the threshold level for the available memory (a
number from 0 to 1).
Service alarms ( Continued)
Alarm name Type MIB point Polling or
trap?
Further details