Specifications

iControl
Supported Device Reference Guide
47
--- Health monitoring alarms ---
These alarms are created by generic.js
Device
Communication
Status/health sysUpTime (RFC1213) Raise a critical condition if the device stops
responding to polling for a time period defined
bypollinterval X retries.
Device Restart Status/health
sysUpTime (RFC1213) Raise a minor condition based on the value of
sysUpTime read is smaller by at least 60 seconds
compared to last reading. The value increase
by 100 every second.
--- Status alarms ---
Control Mode Text/health status Control mode
• 0 = Local control
•1 = Remote control
Redundancy Mode Status/health
status Redundancy mode
•0 = Manual
•1 = Automatic
Redundancy Chain
Position
Text/health
status Chain position in standby
•00 = Backup converter
•01 = Primary converter 1
• 12 = Primary converter 12
Polarization Text/health
status Polarization switch position
•0 = None
•1 = Horizontal
•2 = Vertical
Power Supply A Status/health
status Power Supply ‘A’ Alarm
Power Supply B Status/health
status Power Supply ‘B’ Alarm
Converter bus fault Status/health
status Converter bus fault
Converter Contact
fault
Status/health
status Converter Contact fault
Switch Module fault Status/health
status Switch Module fault
Switch Module Bus
fault
Status/health
status Switch Module Bus fault
write community Status/health
writeCommunity Check the write community defined in the device
correspond to the configured one. This is
important as the plug-in performs SNMP
SET
operations.
1. The switchover can monitor up to 12 converters + 1 backup.
2. This alarm can be set to
UNKNOWN if cvalr data does not match the pattern ?abcdef.
3. This alarm can be set to
UNKNOWN if converter cannot be selected with an SNMP set.
( Continued)
Alarm name Type MIB point Further details