Specifications

Supported Devices
MIBs Used
42
MIBs Used
• SOFTEL-VFLEX-MIB
• SOFTEL-GROUP-MIB
Miteq Inc.
Modulator 172138
A modulator commonly varies some aspect (amplitude, phase or frequency) of an RF carrier (f',
in proportion to a much lower frequency video or digital input signal (fm). In general, the
input frequency components of the modulation typically extend from DC to 100 MHz, except
for fast data links.
In order to preserve the information content superimposed on the RF carrier, one must insure
that the output system bandwidth is adequate to pass both upper and lower sidebands (i.e. fo
+ fm) without distortion. In fact, system amplifier and channel distortion often will add
residual AM or PM modulation to an otherwise clean transmitter.
The plug-in supports the following alarms:
IMPORTANT: Although OIDs in arrays probably will not change during the device runtime, this
should not be assumed to be the case; some cards MAY be hot-plugged or else
software modules disconnected, which could change the available OIDs.
Ordering information
Hardware New in iControl
version
GSM plug-in name Order number
"Modulator 172138" 6.02 SNMP — Miteq modulator IC-SNMP-247
"NSU1 160061" 6.02 SNMP — Miteq NSU1 Switchover IC-SNMP-246
Alarm name Type MIB point Further details
--- Health monitoring alarms ---
Theses alarms are created by generic.js
Device
Communication
Status/health sysUpTime (RFC1213) Raise a critical condition if the device stops
responding to polling for a time period defined
bypollinterval X retries.
Device Restart Status/health
sysUpTime (RFC1213) Raise a minor condition based on the value of
sysUpTime read is smaller by at least 60 seconds
compared to last reading. The value increase
by 100 every second.