Specifications

iControl

Supported Device Reference Guide

Critical high temperature detected Text/Status No

Backup port activated Text/Status No

Ethernet backup port active Text/Status No

Ethernet Gbe Port fail Text/Status No

High temperature warning Text/Status Yes

Critical Software card error Text/Status Yes

Ethernet AutoNegotiation failed Text/Status Yes

Firmware download failure Text/Status Yes

Firmware upgrade failure Text/Status Yes

Voltage error Text/health Yes

Communication Status Status No Raise a critical condition if the device stops

responding to polling for a time period

defined by pollinterval X retries.

Device Restart Status No Raise a minor condition based on the value of

sysUpTime read is smaller by at least 60

seconds compared to last reading. The value

increase by 100 every second.

System uptime Text/Status No

--- MPEG alarms ---

MPEG Sync loss Text/Status No

Output overflow Text/Status No

Program Decoding failure Text/Status No

DSR sync loss Text/Status No

Continuity error on primary port Text/Status No

Input overflow Text/Status No

Program decoding Failure PCR err Text/Status Yes

Program decoding failure unsupported Text/Status Yes

Framrate mismatch Text/Status Yes

Low delay stream in normal mode Text/health Yes

AC gen lock not synched Text/Status Yes

AC Eth dejitter fail Text/Status Yes

Pid Conflict Text/health Yes

MPEG synch loss on backup port Text/Status Yes

Continuity error on backup port Text/Status Yes

(

Continued)

Alarm name Type Optional? Further details