Instruction manual

Page 58
UTY4422-001 Page 58 of 74
Where “xxx” is audio program identifier. Must scroll to end of presence list in order to exit.
P O R T 1 : x x x x R E V E R S E
L : A L A R M R : A L M / C M D
audio port #
audio program identifier
audio.port_routing[ port #]
audio mute status
R E T U R N
P r e s s < S E L E C T >
B1.4.4 Settings Table
S E T T I N G S T A B L E
P r e s s < S E L E C T >
Pressing <SELECT> allows for display of all valid Settings Table entries, including “Last
Acquired” carrier and “Last Requested” carrier settings. Each setting is displayed as a pair of
screens. Scroll through each pair and from pair-to-pair with the right/left arrow keys.
R F I N : a b b b b b . b b c c c
d d . d d d e / e
T A G : f f
P R O G : x x x x x
R E T U R N
P r e s s < S E L E C T >
The Settings Table report screens show the settings for each valid (used) Table where:
RF IN: a is the (optional) RF feed.
FREQ: bbbbb.bb is the carrier downlink frequency in MHz.
Table Entry: ccc is either ACQ or REQ or valid Table entry #, from 1-48.
FEC Rate: e/e is the inner FEC code ratio (either ½, 2/3, ¾, 5/6, 7/8, or ‘-’ if searching)
TAG SITE: ff is the tag-site, from 0-15.
Program: #: xxxxx is up to 5-digit number which, in the PAT, points to the PID for a particular
service’s PMT.
B1.4.5 NC Status
N C S T A T U S
P r e s s S e l e c t
D E L A Y I N G : 0 0 : 0 0 : 0 0