Instruction manual

Page 51
Page 51 of 74 UTY4422-001
S A V E : < E N T E R >
C A N C E L : < S E L E C T >
<ENTER> saves the entry (new setting) and returns to 2nd level screens under “HARDWARE
SETUP>. <SELECT> returns without saving the entry.
B1.3.2 Channel Selection
Tunes IRD to a channel from settings table. Equivalent to a PERMCH terminal command.
S E L E C T C H A N N E L : x x
Where “xx” is a Settings Table entry number between 1 and 48. If the user presses “Select”,
then the ‘xx’ field flashes. Up/down arrows may select a new value. Pressing “Enter” tunes the
IRD to the new channel settings in that Table entry.
B1.3.3 Edit Channel
Edits an entry in the settings table. Equivalent to ADDS and DELS terminal commands.
E D I T C H A N N E L : x x
Where “xx” is a Settings Table entry number. If you press “Select”, then the ‘xx’ field flashes.
Up/down arrows then select a new value between 1 and 48. Pressing “Enter” starts an edit
session on the Table entry. The screens are the same as those under “Current Settings” above.
B1.3.4 Aspect Ratio Settings
A S P E C T R A T I O M O D E
x x x x
Where xxxx is either 4:3, 16:9, or AUTO. Press <SELECT> to enable changes to the aspect
ratio. Press <SELECT> again to lock in the aspect ratio showing on the LCD. Press ¶ or • to
move among the menus.
B1.3.5 Audio Settings
Similar to SETAUDIO terminal command.
A U D I O S E T T I N G S :
P r e s s < S E L E C T >
Moves user to 3rd level screens under “AUDIO SETTINGS.”
Shown for each installed audio channel. Below is shown the nth channel:
P O R T # : n R O U T E : x