Instruction manual

Page 50
UTY4422-001 Page 50 of 74
C L E A R : < E N T E R >
From the screen above, press <ENTER> to clear the e-mail buffer and return to the first (no e-
mail) screen. If e-mail is present, then, after pressing <SELECT> at the above second or third
screen, the following screen (second level) appears:
< E M A I L M E S S A G E >
E Q U I C K B R O
W
N F O X J U
‘<’ and ‘>’ are shown only when scrolling is necessary to view email message. To exit email
screen you must scroll to end of message.
< - - E N D O F E M A I L - - >
E Q U I C K B R O
W
N F O X J U
After pressing <ENTER> the exit screen appears:
R E T U R N :
P r e s s < S E L E C T >
B1.3 HARDWARE SETUP
H A R D W A R E S E T U P
P r e s s < S E L E C T >
This moves the user to 2nd level screens under “Hardware Setup.” In these screens, the user
may make changes to the IRD setup. NOTE: If local control is disables, then changes to current
settings, channel entry/selection, and audio settings are not allowed, and their screens will not be
shown.
B1.3.1 Current Settings
Tunes IRD to a new channel setting per user input. Equivalent to a PERM terminal command.
C U R R E N T S E T T I N G S :
P r e s s < S E L E C T >
Moves user to 3rd level screens under “CURRENT SETTINGS.”
R F I N : x F R E Q : y y y y y . y y
D A T A R A T E : z z . z z z
Where “x” is the RF Switch Feed number (1 to 4), yyyyy.yy is the downlink carrier frequency in
MHz, and zz.zzz is the transport data rate in Mbps. (If the RF Switch option is installed.)
F E C : x / x T A G : y y
P R O G : z z z z z
Where “x/x” is the inner FEC code ratio (1/2, 2/3, 3/4, 5/6, or 7/8); yy is the tag site. For
program designator, zzzzz is a number or wildcard ‘*’.