Instruction manual

Page 40
UTY4422-001 Page 40 of 74
Table 24. LC Display Menus
Note: Screens marked by ‘*’ are not shown if local control is disabled (either programmed
into non-volatile memory at factory or set by COMPEL command). Exception: “Audio
Settings” screen is shown but only “Attenuation” may be changed by local user.
MAIN LEVEL SECOND LEVEL THIRD LEVEL
Home Screen N/A N/A
EMAIL Email Msg
Hardware Setup Current Settings* RF Feed (Optional), Carrier Frequency and Data-rate
FEC rate, Tag Site, and Program #
Save <ENTER> / Cancel <SELECT>
Select Channel*
Edit Channel*
For each possible channel entry...
RF Feed (Optional), Carrier Frequency and Data-Rate
FEC rate, Tag Site, and Program #
Aspect Ratio Mode* 4:3, 16:9, or Auto
Audio Settings* For each port: Route:, Lang:, and Atten:
SNR Alarm Level
SNR Marg Offset
Select Serial1: Aux Data, Modem, Term., or Printer
Select Serial2: Aux Data, Modem, Term., or Printer
Modem Password: 6 alphanumeric char’s max.
Default is ‘PASSWD’
Printer Settings: Baud, Parity
Modem Settings: Baud, Parity
Serial Ports (Both Ports
MUST not be set to the
same device at the
same time. Modem and
Terminal may not be
selected at the same
time.)
Aux Data Settings: Pid, Baud, Parity
Test Mode For Factory Use
LNB DC Power ON or OFF
LNB LO Set Frequency
Unit Reset
Settings Status PERM, TEMP, or SEARCH settingsStatus Reports
RF In, Carrier, Data Rate, FEC Rate
Carrier Status
(Tracking)
Tag, Program
Acq. Mode / Mode Duration
RF In, Carrier Data Rate, FEC Rate
Program ID, Tag Site
EbNo / Margin / Level
Last Acq., / high-low EbNo
First Acq. / Availability
RF Level / EbNo Level Status