Instruction manual

Page 36
UTY4422-001 Page 36 of 74
3.8.1 Perms, Temps, Searching & Settings
The term settings is used throughout this document and includes the following parameters:
Table 19. Settings Parameters
{RF_In}
Value from 1 - 4, specifying the RF input (if RF Switch is installed)
Carrier
The downlink frequency specified in MHz with up to two decimal places.
This value’s absolute difference with the LNB LO frequency must be ≥ 950
MHz and ≤ 2150 MHz.
Data_rate
The data_rate is the MPEG2 transport rate in Mbps. (See Table 3, Page 16,
for allowed ranges.) This value can have up to three decimal places.
FEC_rate
The inner FEC code ratio, which can have one of the following values: 1/2,
2/3, 3/4, 5/6, or 7/8.
Tag_site
Value of 0-15 specifying the location of this carrier’s tag frequency. ‘15’ is
reserved for ‘No Tag Required.’
[program]
The program stream. If omitted or an ‘*’ is entered, the unit will select the
first available program stream. If the number is in the range 1-65535, the unit
will use only the program stream with the corresponding PID number. If a
string is entered, the unit will use only the program with the corresponding
identifier. The unit will support a minimum of three programs. If a carrier
contains more than three programs, the unit will only use the first three.