Owner's Manual

9
JUMP STARTING YOUR ENGINE
1. Ensure your engine is completely OFF.
2. Securely connect the Smarty Clamps™ to your
Weego 66, then power ON.
3. Attach BLACK clamp to your battery’s negative (-)
terminal, then the RED clamp to your battery’s
positive (+) terminal. Adjust your
Smarty Clamps™
to achieve MAXIMUM contact with the terminals.
Poor connections will prevent you from starting your
engine! Clear off any dirt or buildup with a wire brush
or a dry towel before connecting your clamps.
4. Place your Weego 66 in a secure location or
suspend using the provided hook & lanyard so it
won’t fall. Check your
Smarty Clamps™ lights.
5. When you have a GREEN READY light, start your
engine. If the engine doesn’t start, turn off your
vehicle and check your
Smarty Clamps™ lights.
6. After a successful start, quickly disconnect the
Smarty Clamps™ from your Weego 66.
7. Detach the Smarty Clamps™ from the battery.
8. You’re now good to go - be sure to run your engine
for at least 15 minutes before shutting it off again so
it has time to recharge your battery.
If you are having issues getting your engine started,
see Troubleshooting (pages 11-12) for further
details and assistance.
Connect Clamps
Power ON
Attach BLACK (-),
Then RED (+)
Connect Clamps
Power ON
Attach BLACK (-),
Then RED (+)
Once it Starts,
Disconnect Clamps
from Weego 66
Detach Clamps
From Battery
When You Have
GREEN Light,
Start Your Engine
When You Have
GREEN Light,
Start Your Engine
Once it Starts,
Disconnect Clamps
from Weego 66
Detach Clamps
From Battery