Owner's Manual

JUMP STARTING YOUR ENGINE
1. Ensure your engine is completely OFF.
2. Securely connect the Smarty Clamps™ to your
Weego 44, then power ON.
3. Attach BLACK clamp to your battery's negative ( ·)
terminal, then the RED clamp to your battery's
positive (+) terminal. Adjust your Smarty Clamps™
to achieve MAXIMUM contact with the terminals.
Poor connections will prevent you from starting your
engine! Clear off any dirt or buildup with a wire brush
or a dry towel before connecting your clamps.
4. Place your Weego 44 in a secure location or
suspend using the provided hook & lanyard so it
won't fall. Check your Smarty Clamps™ lights.
5. When you have a GREEN READY light, start your
engine. If the engine doesn't start, turn off your
vehicle and check your Smarty Clamps™ lights.
6. After a successful start, quickly disconnect the
Smarty Clamps™ from your Wee go 44.
7, Detach the Smarty Clamps™ from the battery.
8. You're now good to go- be sure to run your engine
for at least 15 minutes before shutting it off again so
· it has time to recharge your battery.
If you are having issues getting your engine started,
see Troubleshooting (pages 11-12) for further
details and assistance.
...
9