Owner's Manual

JUMP STARTING YOUR ENGINE
1. Ensure your engine is completely OFF.
2. Securely connect the Smarty Clamps
1
M
to your
Weego 44, then power ON.
3. Attach BLACK clamp to your battery's negative (-)
terminal, then the RED clamp to your battery's
positive (+) terminal. Adjust your Smarty Clamps 1M
to achieve MAXIMUM contact with the terminals.
Poor connections will prevent you from starting your
engine! Clear off any dirt or buildup with a wire brush
or a dry towel before connecting your clamps.
4. Place your Weego 44 in a secure location or
suspend using the provided hook & lanyard so it
won't fall. Check your Smarty Clamps 1M lights.
5. When you have a GREEN READY light, start your
engine. If the engine doesn't start, turn off your
vehicle and check your Smarty Clamps 1M lights.
6. After a successful start, quickly disconnect the
Smarty Clamps 1M from your Wee go 44.
7. Detach the Smarty Clamps 1M from the battery.
8. You're now good to go - be sure to run your engine
for at least 15 minutes before shutting it off again so
it has time to recharge your battery.
If you are having issues getting your engine started,
see the Troubleshooting section in your owner's
manual for further details and assistance.