Use and Care Manual
12
sometimes it goes much deeper than that. There may be other functions
in your vehicle that aren’t working properly, thus preventing a successful
engine start. Please refer to your vehicle owner’s manual or visit your local
service garage to determine what the issue may be.
I accidentally connected my clamps to one another. Have I damaged my Weego?
l Remove the clamps from the Weego and press the power button. If the
indicator lights are still on, you have not damaged your Weego.
l Connecting the clamps to one another creates a short circuit. You could have
blown the safety fuse on your black clamp. If so, you will need a new set of
clamps. To order a new set of clamps, please visit www.myweego.com/support.
I accidentally connected the clamps to the wrong terminals. Have I damaged
my Weego?
l Remove the clamps from the Weego and press the power button. If the
indicator lights are still on, you have not damaged your Weego.
l You could have experienced a reverse polarity and blown the safety diode on your
red clamp. To order a new set of clamps, please visit www.myweego.com/support.
I connected my portable device to my Weego with a USB but it will not charge.
l After connecting a device to your Weego be sure to power ON the Weego.
l Make sure the Weego is charged. If no indicator lights illuminate after power-
ing on the device, charge your Weego.
l If you are charging more than 2 devices on the 3-in-1 USB cable you need to
remove one of the devices as there is only enough current for two.
l Make sure the USB cable is securely connected to the Weego.
l You may have a faulty USB cable.
I connected my Weego to the charger but there are no indicator lights blinking.
l Check that the charger is securely attached to the Weego input port.
l You may have a faulty outlet. Try plugging your Weego charger into an
alternate outlet.
l Make sure you are using the input port and not any of the output ports.
I am unable to turn on the ashlight.
l Make sure your Weego is charged.
l Be sure to hold the ON/OFF button for 3 seconds to activate the ashlight.
My Weego will not power on.
l Charge your Weego. You should eventually see blinking indicator lights once
the Weego has enough charge.