User Guide

UNDERSTANDING YOUR Smarty Clamps
®
Your Smarty Clamps
®
have a “smart” box that will help guide you through a
jump with both sight and sound. It will let you know when it is safe to jump or
if there is an error.
Flashing Green & Red Lights + Beeping
REVERSE +/-
You attached the Smarty Clamps
®
on the wrong
terminals. Make sure the BLACK clamp is attached to the
battery’s NEGATIVE (-) terminal, and the
RED clamp is
attached to the battery’s
POSITIVE (+) terminal. If not
attached properly, Weego 44 will not let you jump your engine.
READY
Flashing Green Light, No Sound
Smarty Clamps
®
detect that you have a good connection
and you are ready to jump.
There’s a voltage incompatibility. The battery is too weak to
even start OR the system voltage of your vehicle is not
compatible with your Weego 44 (for 12V vehicles ONLY).
Solid Red Light, No Sound
There may be an engine incompatibility issue if the engine
you’re connecting to is demanding more power than the
Weego is able to give (440A). Please see Engine
Compatibility in the owner’s manual to determine if your
engine size falls within the scope of Weego 44.
SEE BACK
Solid Red Light + Beeping
SEE BACK
COOL DOWN
WAIT FOR
Flashing Red Light + Beeping
The Weego battery overheats after long cranks or excessive
current draw. Detach the Smarty Clamps
®
from the battery
and give the unit up to 3 minutes to cool down. Then, repeat
steps 2-5 under Jump Starting Your Engine.
Either you have a poor connection, or your battery voltage
is near 0 volts. Press Bypass Button, when green LED is on,
start engine.
No Light (or Solid Red Light + Beeping)