JUMP STARTING POWER PACK QUICK START GUIDE Model No. 44.
GETTING TO KNOW WEEGO 44 Battery Indicator Lights Flashlight Button Detect-O-Matic™ USB Port 5V, 9V or 12V/2.4A 12V/10A Accessory Port (Black) Smarty Clamps® Socket Back of Unit 500 Lumen LED Lights Power ON/OFF Button Lanyard Post 15V/1A Recharge (Input) Port Smarty Clamps® CHARGE UP YOUR WEEGO 44 When you unpack your new Weego 44 for the first time, charge it up to 100% with either the wall or car charger provided.
JUMP STARTING BEFORE YOU JUMP Read all instructions and safety information prior to using this product. Improper use of this product will void your warranty and may result in product damage, excess heat, toxic fumes, fire, and other unsafe conditions for which Weego is not responsible. Read vehicle owner’s manual first: it may have specific cautions and instructions about jumping your engine.
Connect Clamps Power ON Attach Black (-), Then Red (+) When You Have FLASHING GREEN LIGHT On Your Smart Box, Start Your Engine Once it Starts, Disconnect Clamps from Weego 44 Detach Clamps From Battery
JUMP STARTING YOUR ENGINE 1. Ensure your engine is completely OFF. 2. Securely connect the Smarty Clamps® to your Weego 44, then power ON. 3. Attach BLACK clamp to your battery’s negative (-) terminal, then the RED clamp to your battery’s positive (+) terminal. Adjust your Smarty Clamps® to achieve MAXIMUM contact with the terminals. Poor connections will prevent you from starting your engine! Clear off any dirt or build-up with a wire brush or a dry towel before connecting your clamps. 4.
UNDERSTANDING YOUR Smarty Clamps® Your Smarty Clamps® have a “smart” box that will help guide you through a jump with both sight and sound. It will let you know when it is safe to jump or if there is an error. READY Flashing Green Light, No Sound Smarty Clamps® detect that you have a good connection and you are ready to jump. REVERSE +/- Flashing Green & Red Lights + Beeping You attached the Smarty Clamps® on the wrong terminals.
TROUBLESHOOTING Visit www.myweego.com/support for FAQs and additional troubleshooting inquiries and details. My unit won’t power on/charge/charge past a few lights If your unit won’t power on, won’t take a charge OR won’t charge past a few lights then it’s been overdischarged. This can happen if the unit is left ON, or if an engine pulled the Weego battery past a certain limit during a jump start. Please reach out to support@myweego.
USB CHARGING Charge your phone, tablet and other portable devices with your Weego 44 using your own USB charging cord. Your Weego 44 comes equipped with Detect-o-Matic™ USB Charging. This intelligent charger communicates with your device to detect and deliver the fastest-possible charge. To charge your devices, plug your charging USB Charging Port cord into your Weego 44 USB port and connect to your device.
