Material Safety Data Sheet

Shenzhen Anbotek Compliance Laboratory Limited
Page 7 of 8
Report No. R0117030156B
This Test Report is issued by the Company subject to its General Conditions of Service printed overleaf. Attention is drawn to the limitations
of liability, indemnification and jurisdictional issues defined therein. The results shown in this report refer only to the sample(s) tested unless
otherwise stated. This Test Report cannot be reproduced, except in full, without prior written permission of the company.
Shenzhen Anbotek Compliance Laboratory Limited
Address: East of 4/F., Building A, Hourui No.3 Industrial Zone, Xixiang Street, Bao'an District, Shenzhen, Guangdong, China
Tel: (86) 755-26066061
Fax: (86)755-26066021 Email: service@anbotek.com Http: //www.anbotek.com.cn
1. Disposal of the battery should be performed by permitted, professional disposal firms
knowledgeable in Federal, State or Local requirements of hazardous waste treatment and
hazardous waste transportation.
2. The battery should be completely discharged prior to disposal and/or the terminals taped or
capped to prevent short circuit. When completely discharged it is not considered
hazardous.
3. The battery contains recyclable materials. Recycling options available in your local area
should be considered when disposing of this product, through licensed waste carrier.
According to PACKING INSTRUCTION 965of IATA DGR 58th Edition for transportation,
the special provision 188 of IMDG (inc Amdt 38-16). The batteries should be securely packed
and protected against short-circuits. Examine whether the package of the containers are
integrate and tighten closed before transport. Take in a cargo of them without falling, dropping,
and breakage. Prevent collapse of cargo piles. Don’t put the goods together with oxidizer and
chief food chemicals. The transport vehicle and ship should be cleaned and sterilized before
transport. During transport, the vehicle should prevent exposure, rain and high temperature.
For stopovers, the vehicle should be away from fire and heat sources. When transported by sea,
the assemble place should keep away from bedroom and kitchen, and isolated from the engine
room, power and fire source. Under the condition of Road Transportation, the driver should
drive in accordance with regulated route, don’t stop over in the residential area and congested
area.
(a) UN number
3480
(b) UN Proper shipping name
LI-POLYMER BATTERIES (including lithium ion batteries)
(c) Transport hazard class(es)
9
(d) Packing Instruction (if applicable)
965 II/ IB
(e) Marine pollutant (Yes/No)
No
(f) Transport in bulk (according to Annex II of MARPOL 73/78 and the IBC Code)
No information available.
Section 14. Transport Information
Section 13. Disposal Considerations