User Manual

Assemble WeeeBot
Wiring
3X 4P4C RJ11 Cable-20cm
AA Battery Holder
18650 Battery Holder
LED Panel Module
RGB Ultrasonic Sensor
Line-following Sensor
Tips
1. Motor M1 wire to port M1, motor M2 wire to port
M2. (Motor cable: black wire on the left, white wire
on the right)
2. Sensor wiring port as follow:
Port A ⸺ Line-following Sensor
Port B ⸺ RGB Ultrasonic Sensor
Port C ⸺ LED Panel Module
Note: You can plug RJ11 sensor or electronic
module to any one of four RJ11 port, that plugged
sensor or electronic module will be automatically
identified by mainboard ELF.
Tip:“***”stands for extended accessories that not included in package,
such as Bluetooth module, 2.4G module.
Steps:
1. Wiring RJ11 cable on all sensors and electronic modules, take the other
open end of RJ11 cable out of WeeeBot body structure.
2. After Step 9, connect the open end of RJ11 cable with ELF mainboard.