User Guide

V1.0
PROGRAMMING
Online Coding Mode
Your robot has default factory firmware in main controller, which will not respond to project running on computer.
To create your own project on computer, and control the robot through the command from computer, please
follow below step:
Before you create your own project, please click “Arduino”, select “Restore firmware” -> “Restore Online
Firmware” to activate the board. Then the robots will respond to coding blocks you dragged into coding zone.
Coding
To start a new project, go to WeeeCode and click “Project” -> “New”.
To load a project, go to WeeeCode and click “Project” -> “Load”.
To save a project, click “Project” -> “Save”.
To modify and save a project, click “Project” -> “Save As”.
! of !4 6
WEEEMAKE CO., LTD.