V1.0 WEEEMAKE CO., LTD WeeeCode User Guide Prepared by: Weeemake Co., Ltd. Version number: 1.
V1.0 WEEEMAKE CO., LTD. INSTALLATION AND CONNECT Download the WeeeCode Installer WeeeCode will work on Mac and Windows. Please download software on below website: http://www.weeemake.com/?page_id=424 Installation Open the WeeeCode Installer package and follow software guide to install. ***Tip: For Mac OS, please enter “System Preferences” -> “Security & Privacy” and allow your computer install WeeeCode.
V1.0 WEEEMAKE CO., LTD. Install Driver For Windows system, driver will be installed at the same time while installing WeeeCode. For Mac OS system, once finished installation, please click “Driver” on WeeeCode menu bar, and install driver for hardware. Connect Once driver installed, your computer can identify WeeeMake robot. Follow below steps to connect your robot to your computer: • Use USB cable connect your robot to your computer, select the robot type.
V1.0 WEEEMAKE CO., LTD. PROGRAMMING Online Coding Mode Your robot has default factory firmware in main controller, which will not respond to project running on computer. To create your own project on computer, and control the robot through the command from computer, please follow below step: Before you create your own project, please click “Arduino”, select “Restore firmware” -> “Restore Online Firmware” to activate the board. Then the robots will respond to coding blocks you dragged into coding zone.
V1.0 WEEEMAKE CO., LTD. Drag blocks from left window to middle window in a logical way, to create your project. Offline Coding Mode You can upload your project to main board, so robot will run your program without computer connection. 1. Create project start with block when program begin in “WeeeBot” section. 2. Click “Arduino” -> “Upload”.
V1.0 Restore Factory Program Please remember to restore the firmware program to you robot after coding, so the default function of IR remote control and APP control will not be influenced. To restore factory firmware, please click “Arduino”, select “Restore firmware” -> “Restore Factory Firmware”.
