(_ Trademark Por favor, el producto al lugar de compra. Please do no not devuelva return product to retailer. Veuillez ne pas retourner le produit au detaillant. • 1-800-554-6723 Register your product online at: Registre su producto en linea en: Enregistrez votre produit en ligne a I'adresse : www.weedeater.
,_/LDANGER: Use only specified trimmer head, spool, and 0.080 inch (2 mm) recommended trimmer line. Never use blades, flailing devices, wire, rope, string, etc. Unit is designed for line trimmer use only. Failure to follow these instructions may result in serious injury. ®®®® use can cause serious injury. J ,II_WARNIN_: This unit can be dangerous! _J Careless or improper follow instructions could result in serious injury to the operator and/or bystanders.
Store unitindoors inahigh, dryplace outofthereach of children. When servicing unit, use only identical replacement parts. Always stop unitand disconnect spark plug before cleaning orservicing. j _selhWeAuRNnleNarG afrirehazsardarNe_erclumi_nP°U rmo_ris_°repga_/ines°,ror work that cancause sparks). Use unleaded 40:1 (2.5%).
• Secure hair above shoulder length. Secure or • remove loose clothing orclothing with loosely hanging ties, straps, tassels, etc.They can becaught inmoving parts. • Being fully covered also helps protect you from debris and pieces oftoxic plants thrown • byspinning line. • Stay Alert. Donotoperate thisunit when you are tired, ill,upset orunder theinfluence ofal- • cohol, drugs, ormedication. Watch what you aredoing; use common sense. • •• Wear hearing protection.
Fornormal homeowner use, themuffler and spark vice. arresting screen will not require any ser- After 50 hours of use, we recommend that your muffler be serviced or replaced by your authorized service dealer. ATTACHING SHIELD m_WARNINu: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure. WARNING: The shield must be properly installed.
STOP SWITCH CHOKE The STOP switch isused tostop theengine. To TheCHOKE helps tosupply fuel totheengine stop theengine, push and hold theswitch inthe to aid in cold starting. Activate the choke by STOP position until theengine stops. moving the choke lever to the FULL CHOKE position. After the engine attempts to start, move PRIMER BULB choke lever to the HALF CHOKE position. ThePRIMER BULB removes airfrom thecar- the engine has started, move the choke lever buretor and fuellines and fillsthem with fuel.
Primer STARTING A FLOODED ENGINE Flooded engines can be started by placing the choke lever in the RUN position; then, pull the rope to clear the engine of excess fuel. This could require pulling the starter handle many times depending on how badly the unit is flooded. If the unit still doesn't start, refer to TROUBLESHOOTING TABLE or call 1-800-554-6723. Bulb OPERATING Choke Lever INSTRUCTIONS It is recommended that the engine not be operated for longer than 1 minute at full throttle.
TRIMMER LINE ADVANCE The cutting head advances line automatically, Do not tap head on the ground to advance line. This may break parts and cause cutting head to malfunction. Upon unit start up, the line will advance automatically to the correct cutting path length. Always keep the shield in place when the tool is being operated. ,_ WAR NI N G: Useonly0.080" (2 mm) diameter round line.
EDGING - Adjust trimmer to the edging position (see TWIST AND EDGE section). Allow only the tip of the line to make contact. Do not force trimmer line into work area. Edging 1. aWARNIN_: Disconnect the spark plug before performing maintenance except for carburetor adjustments. 2. Clean the air filter cover and the area around it to keep dirt from falling into the carburetor chamber when the cover is opened. Open air filter cover by pushing button NO (seeTE: illustration). Removea fire air filter.
LINEREPLACEMENT INSTALLING SPOOL WITH Pre-wound spools offer themost convenient1. Install replacement spool. 2. Thread line through line guide method forreplacing lineand ensuring optimum performance. * Replacement spools are color-coded to ensure use of the correct spool with your unit. Be sure to use the same color spool as the existing spool. NOTE: Always clear dirt and debris from cutting head components when performing any type of maintenance. .
m_WARNINu:Perform the following steps after each use: • Allow engine to cool, and secure the unit before storing or transporting. • Store unit and fuel in awell ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. • Store unit with all guards in place. Position unit so that any sharp object cannot accidentally cause injury. • Store unit and fuel well out of the_reach of children.
TROUBLESHOOTING ,_ TABLE WARNI NG: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit. TROUBLE CAUSE REMEDY Engine will not start. 1. Engine flooded. 1. See "Starting a Flooded Engine" in Operation Section. 2. Fill tank with correct fuel mixture. 3. Install new spark plug. 4. Check for dirty fuel filter; replace. Check for kinked or split fuel line; repair or replace. 5.
WEED EATER, a division of Husqvarna Consumer Outdoor Products N.A., Inc., warrants to the original consumer purchaser that each new WEED EATER brand gasoline tool or attachment is free from defects in material and workmanship and agrees to repair or replace under this warranty any defective gasoline product or attachment as follows from the original date of purchase. 2 YEARS - Parts and Labor, when used for household purposes.
glect, improper maintenance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. You are responsible for presenting your small off-road engine to an WEED EATER authorized repair center as soon as a problem exists. Warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.
