User Manual

ManualsBrandsWeed Eater ManualsRoutersNetwork Router 2600

Cisco High-Density Analog Voice and Fax Network Module

Configuration Tasks

Cisco IOS Release 12.2(2)XT and 12.2(8)T

Tone Injection Tests

To inject a test tone into a voice port, use the following commands in privileged EXEC mode:

Relay-Related Function Tests

To test relay-related functions on a voice port, use the following commands in privileged EXEC mode:

Command Purpose

Step 1

Router# test voice port slot/subunit/port inject-tone

{local | network} {1000hz | 2000hz | 200hz | 3000hz |

300hz | 3200hz | 3400hz | 500hz | quiet}

Identifies the voice port you want to test and enters

keywords for the direction to send the test tone and

for the frequency of the test tone.

Note A call must be established on the voice

port under test.

Step 2

Router# test voice port slot/subunit/port inject-tone

disable

Identifies the voice port on which you want to end

the test and enters the keyword disable to end the

test tone.

Note The disable keyword is available only if a

test condition is already activated.

Command Purpose

Step 1

Router# test voice port slot/subunit/port relay

{e-lead | loop | ring-ground | battery-reversal |

power-denial | ring | tip-ground} {on | off}

Identifies the voice port you want to test. Enter a

keyword for the relay under test and specify

whether to force it to the on or off state.

Note For each signaling type (FXO, FXS), only

the applicable keywords are displayed.

The disable keyword is displayed only

when a relay is in the forced state.