Manual

ManualsBrandsWeed Eater ManualsBlowerEBV VS

Trademark

i_ Please do not return unit to retailer.

Por favor, no devuelva el aparato al lugar de compra.

Veuillez ne pa8 retourner I'outil au detaillant.

• 1-800-554-6723

www.weedeater.com

Instruction Manual

Manual de Instrucciones

Manuel d'lnstructions

FOR HOUSEHOLD USE ONLY

PARA USO CASERO SOLAMENTE

POUR UTILISATION .& DES FINS

DOMESTIQUES SEULEMENT

EBV VS B

C@US

WARNING:

Read and follow all Safety Rules and Operating Instructions before

using this product. Failure to do so can result in serious injury.

ADVERTEN ClA:

Lea el manual de instrucciones y siga todas las advertencias e

instrucciones de seguridad. El no hacerlo puede resultar en lesiones

graves.

AVERTISSEMENT:

Veuillez life le manuel d'instructions et bien respecter tous les

avertissements et toutes les instructions de securit& Tout defaut

de le faire pourrait entraTner des blessures graves.

Electrolux Home Products, Inc. Electrolux Canada Corporation

104 Warren Road 6150 McLaughlin Road

Augusta, GA 30907 Mississauga, Ontario L5R 4C2

[_ The Elecbolux Group. 77_ world's No. 1 choice.

KrFCHEN, CLEANING ,_ND OI_TBO0_ AppUANCES COMBI,VB'B

Summary of content (11 pages)

PAGE 1
Trademark i_ Por favor, el aparato Please do no not devuelva return unit to retailer.al lugar de compra. Veuillez ne pa8 retourner I'outil au detaillant. • 1-800-554-6723 www.weedeater.com Instruction Manual Manual de Instrucciones Manuel d'lnstructions FOR HOUSEHOLD USE ONLY PARA USO CASERO SOLAMENTE POUR UTILISATION .& DES FINS DOMESTIQUES SEULEMENT EBV VS C@US WARNING: Read and follow all Safety Rules and Operating Instructions before using this product.
PAGE 2
IMPORTANT WARNINGS AND SAFETY INSTRUCTIONS ,AWARNING: When using electric gardening appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and serious injury. The warnings and safety instructions in this manual must be followed to reduce the risk of fire, electric shock, or injury, and to provide reasonable safety and efficiency in using this unit. The operator is responsible for following the warnings and instructions in this manual and on the unit.
PAGE 3
• Keep theextension cordclear ofoper- UNIT/MAINTENANCE SAFETY atorandobstacles atalltimes. Donot • Turn off all controls and allow the motor expose cordstoheat,oil,water, or to stop before disconnecting the unit sharp edges. from the power source. • Avoidanybodycontact withany • Disconnect the unit from the power grounded conductor, suchas metal source when not in use. Do not leave fences, orpipes, toavoid thepossibility the unit when it is plugged into outlet. ofelectric shock.
PAGE 4
• Useonlyrecommended attachmentscause serious injury to the operator or andreplacement parts toavoid creating others. ahazard and/or voiding warranty. • When using the vacuum attachment, • Maintain theunitaccording torecom- the unit is designed to pick up dry matemended procedures. rial such as leaves, grass, small twigs, • Useonlyforjobsexplained intheOP- and bits of paper. Do not vacuum ERATION section ofthismanual. stones, gravel, metal, broken glass, etc.
PAGE 5
dt_WARNING: Stop the unit and disconnect from the power source before opening the inlet cover or attempting to insert or remove the inlet restrictor, blower tube, or vacuum tubes. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades. WARNING: If received assembled, ensure your unit is properly assembled and all fasteners are secure. • A standard screwdriver is required for assembly.
PAGE 6
Upper Vacuum Tube Vacuum Assist Handle Last Int_ Hook _I\ Retaining Post 4. Toattach thelower vacuum tubeto theupper vacuum tube, firstalign the arrows onthetwotubes. Then, press thetwotubes together untilthelower tubeissecurely seated intheupper tube(about 3inches). z_ Upper TubeLower Tube _ _J" /I"-_j 2. Position the unit on your right-hand side, blower outlet and bag pointing toward the rear. Hold the unit in an upright position with the lower vacuum tube on the ground to support it. 3.
PAGE 7
NOTE: Ifyouareunable tolocate the • Heavy enough to carry full current from inletrestrictor, theunitwillstilloperate. the power source to the unit. Otherwise, Thisrestrictor improves theblower loss of power and overheating can ocfunction. cur causing damage to unit. Refer to table for minimum wire gauge recom4. Remove the collection bag. 5. Close the inlet cover and make sure mendations. The cord must be marked itislatched closed. with the proper wire gauge. (Appropriate 6. Re-install theblower tube.
PAGE 8
KNOW YOUR ELECTRIC BLOWER READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERAT- ING YOUR UNIT. Compare the illustrations to your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. ON/OFF Switch/___ _,_-_ Variable Speed Control Collection Bag Cord (__ Air Vents Elbow Tube Retainerr._.___ I_( -HR:nad, _ \t _ Inlet Cover Latch I Upper Vacuum Tube Retaining Post Vacuum Assist Handle __._.
PAGE 9
NOTE: The variable speed control will not function with the switch in the • Blowing grass clippings, straw, or leaves into piles, or removing debris from corners, around joints, or between bricks. Direct air flow by directing the blower tube down or to one side. Always work away from solid objects such as walks, large stones, vehicles, and fences. Clean corners by starting in corners and moving outward. This will help prevent an accumulation of debris which could HIGH (high speed) position.
PAGE 10
• ON/OFF Switch - Ensure switch func- CLEAN COLLECTION BAG tionsproperly bymoving theswitch to IMPORTANT: THE COLLECTION BAG theOFFposition. Makesuremotor MUST BE PROPERLY EMPTIED. stops; thenrestart motor andcontinue.• You must properly empty and maintain • InletCover - Discontinue useofunitif the collection bag to avoid deterioration inlet cover fails tolatch properly orifitis and obstruction of air flow. damaged inanyway. • Remove the collection bag from the unit and empty after each use.
PAGE 11
TROUBLESHOOTING TABLE _L WARNING: Always stop unit and disconnect from the power source before performing all of the recommended remedies below except remedies that require unit to be operating. REMEDY SYMPTOM CAUSE Unit fails to 1. Slide switch to HIGH orVAR 1. Switch in the OFF position. operate. position. 2. Reconnect 2. Extension cord disconnected. 3. Circuit breaker tripped, or fuse blown. 4. Mechanical failure Unit vibrates abnormally. 1. Mechanical Impeller will not turn freely. 1.