Operator's Manual

5
ASSEMBLY
WARNING: I f received assembled,
ensur e your unit is properly assem bled
and all fasteners are secure.
ATTACHING THE BLOWER T UB E
1. Align the grooves on the blower tube
with the grooves on the blower outlet.
2. Push the blower tube onto the blower
outlet until it snaps into place (tube is
secured by yellow tube release but-
ton).
3. To remove the blower tube, press the
tube release button while pulling on
tube.
Blower Tube
Blower outlet
Tube Release Button
SELECT AN EXTENSION CORD
Use only a 120 A.C. voltage sup ply as
shown on nameplate of the unit to
power your blower.
Theextensioncordusedtoreachthe
power source must be:
D Specifically marked as suitable for out-
door use. The cord must be marked with
the suffix “W”.
D Heavy enough to carry ful l curr e nt f rom
the power source to the unit. Other wise,
loss of power and over heati ng can oc-
cur causing damage to unit. Ref er to
tab le for mini m u m wir e gauge recom-
mendations. The cord must be marked
wit h the proper wire gauge. (Appropr iat e
extension cords are available. ) Do not
use multi pl e cords.
D In good condition. Cord insulation must
be intact wi th no cr acks or deteri oration.
Plug connectors must be undamaged.
DO NOT use mul tipl e cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOL TS
25 FT. 50 FT. 100 FT.
120
16
A.W.G.*
16
A.W .G.*
*American Wire Gauge
14
A.W.G.*
Secur e the extension cord to the unit by
threading the cord through the cord re-
tainer (see illustration). Insert the cord
rece ptacle int o the rece ssed plug.
CAUTION: Failuretousecordretain-
er could result in damage to the unit,
extension cord, or both.
Cord
Retainer
Cord
Receptacle
Recessed
Plug
on Unit