ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l’outil au détaillant. 1-800-554-6723 www.weedeater.com Instruction Manual Manual de Instrucciones Manuel d’Instructions WEED EATER 1030 Stevens Creek Road Augusta, GA 30907 545117552 Rev. 2 8/2/07 BRW FRANÇAIS WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury.
SAFETY RULES S Don’t overreach or stand on unstable support. Keep good footing and balance at all times. WARNING: When using gardening appliances, basic safety precautions must always be followed to reduce the risk of fire and serious injury. Read and follow all instructions. This power unit can be dangerous! Operator is responsible for following instructions and warnings on unit and in manual.
WARNING: Thrown objects Safety Glasses Blade can throw objects violently. D You can be blinded or injured. D Wears safety glasses or similar eye protection. Boots WARNING: Hazard zone for thrown objects. D Blade can throw objects violently. D Others can be blinded or injured. D Keep people and animals 50 feet (15 meters) away. 50 pieds (15 m) Blade rotates momentarily after the trigger is released. Allow blade to stop before removing it from the cut.
strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An anti-vibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condition of this tool. SAVE THESE INSTRUCTIONS ASSEMBLY 3. Thread one locknut onto each screw and tighten securely.
OPERATION KNOW YOUR EDGER READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
4. Squeeze and hold the throttle trigger. Keep throttle trigger fully squeezed until the engine runs smoothly. cleaner products in the fuel tank or permanent damage may occur.See the STORAGE section for additional information. STOPPING YOUR ENGINE S To stop a running engine, move the switch to the OFF position. S If engine does not stop, move choke lever to FULL CHOKE position. ON/OFF Switch 5.
OPERATING INSTRUCTIONS ON/OFF switch to the OFF position, and disconnect spark plug before making adjustments. Your edger is equipped with several edging depths. The depth used will depend on your personal edging preference and the condition of the area where the edging operation is to be done. NOTE: If the area to be edged has never been cut or several weeks have passed since the last cut, the first edging should be done at no more than half depth.
bypassing the filter and to keep dust from entering engine and causing damage. 8. Reinstall air filter cover. S ON/OFF Switch -- Ensure ON/OFF switch functions properly by moving the switch to the OFF position and assure the engine stops; then restart engine and continue. S Fuel Tank -- Discontinue use of edger if fuel tank shows signs of damage or leaks. S Blade Guard -- Discontinue use of edger if blade guard is damaged.
SERVICE AND ADJUSTMENTS BLADE REPLACEMENT Keep others away when making idle speed adjustments. Remove the blade before making carburetor idle speed adjustments. Do not make adjustments from the blade side of the unit. Recheck the idle speed after each adjustment. The blade must not spin at idle speed to avoid serious injury to the operator or others. Make adjustments with the unit supported so the blade is off the ground and will not make contact with any object.
STORAGE WARNING: Perform the following steps after each use: S Allow engine to cool before storing or transporting. S Store unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. S Store unit with all guards in place. Position unit so that any sharp object cannot accidentally cause injury. S Store unit and fuel well out of the reach of children.
TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit. TROUBLE CAUSE REMEDY Engine will not start or will run only a few seconds after starting. 1.ON/OFF switch in OFF position. 2. Engine flooded. 1. Move ON/OFF switch to the ON position. 2. See “Difficult Starting” in Operation Section. 2. Fill tank with correct fuel mixture. 3. Install new spark plug. 4.
LIMITED WARRANTY WEED EATER warrants to the original purchaser that each new WEED EATER brand gasoline tool or attachment is free from defects in material and workmanship and agrees to repair or replace under this warranty any defective gasoline product or attachment as follows from the original date of purchase. 2 YEARS--Parts and Labor, when used for household purposes. 90 DAYS--Parts and Labor, when used for commercial, professional, or income producing purposes.
which leads to the determination that a warranted part is defective if the diagnostic work is performed at an approved Poulan/WEED EATER servicing center. CONSEQUENTIAL DAMAGES: Poulan/WEED EATER may be liable for damages to other engine components caused by the failure of a warranted part still under warranty. WHAT IS NOT COVERED: All failures caused by abuse, neglect, or improper maintenance are not covered.
