Specifications

54
Carburetor Part Replacement and Rebuild
Follow the listed steps and video tutorial link below to replace parts and
rebuild your Weed eater carburetor:
Safety: Do not forget to use safety glasses and gloves
1. Purchase a carburetor kit suitable for your model. Normally two types
of kits exist where one kit contains the diaphragm gaskets only and the second
kit contains all replacement parts for the carb including the
diaphragm gaskets.
2. Refit the metering lever, metering needle and spring. Refit the screw to
ensure that the metering assembly is in place.
3. Refit the backing plate and gasket by inserting the screws.
4. The metering lever should be fitted such that it is flush with the backing
plate. Use the metering level tool if required to set the height.
5. Refit the metering diaphragm and gasket
6. Refit the primer bulb end plate. The end cap fits only one way so do not
be concerned about fitting it incorrectly.
7. Refit the primer bulb by inserting the 4 screws. Check the primer bulb is
not holed.
8. Turn the carburetor over and refit the gasket and diagraph.
9. Refit the end plate. Hold back the throttle mechanism to allow this plate
to be refitted.
10. Refit the HI and LO fuel adjusting screws.
11. Refit the carburetor to the engine by inserting the filter housing bolts
through the carburetor.