Specifications

of working as well. The basic phenomenon that one must know is that it's all

about the fuel reaching to the carburetor without any delay and then the

engine will work smoothly.

Coming back to the use of the premier bulbs, one must know the fact the

primer bulbs have to be pushed before the start of the engine. Now there

would be question arising in the mind and that would be why it is always

necessary to use the primer bulbs before the starting of the engine? The fuel

reservoir will refer to the fuel tank. Every time the fuel is pumped in at the

carburetor there is vacuum developed in the carburetor upper part. The upper

part of the carburetor is the one that is receiving the fuel but the point is that

the when the fuel moves from the upper chamber to the carburetor to the

lower chamber it creates the vacuum between the two chambers. As a result

of the vacuum between the two chambers the fuel fails to reach the lower

chamber less than the required amount. Thus the engine will unable to start

for the first time.

What these bulbs do is that they fetch the fuel in the required amount from

the fuel reservoir and then this fuel is transferred to the throttle of the engine.

The throttle is that part of the engine that controls the intake of the fuel.

There is a spray machine installed in the throttle that makes sure that the fuel

mixture reaches the combustion engine in the required form. Whenever the

user throttles more the amount of the spray also increases in the combustion

engine. In combustion engine the fuel is burned with the air thus generating

the power for the engine. The uses of the bulbs thus provide help to the

carburetor to start early having enough fuel supplied. These bulbs are pressed

3-4 times so as to make sure that enough fuel has reached its destination.

The next step will be monitoring of the chokes. There are three levels of the

chokes that provide one is the initial level and then there are medium level

and the last one is the full level. When you have to start the engine you have

to set the level of the choke to the last level that is the highest or the full

choke position. Through this it would be sure that the required amount to fuel

for the time to start the engine will be supplied to the engine quickly. That will

not only save your time but it will also save some fuel along with eh energy of

the engine to start and run smoothly. The level of the choke can be adjusted

with the hands as well. These levers are present just near the carburetors and