Specifications

34
- Mix and pour fuel outdoors.- Keep away from sparks or flames.- Use a
container approved for fuel.- Do not smoke or allow smoking near fuel or the
unit.- Wipe up all fuel spills.- Move at least 10 feet (3 meters) away from
fueling site before starting engine.- Stop engine and allow to cool before
removing fuel cap.
CUTTING SAFETY
- Use only for trimming, mowing, and sweeping. Do not use for edging,
pruning, or hedge trimming.- Inspect the area before each use. Remove
objects (rocks, broken glass, nails, wire,etc.) which can be thrown by or
become entangled in line. Hard objects can damage trimmer head and be
thrown causing serious injury.- Keep firm footing and balance. Do not
overreach.- Keep all parts of your body away from spinning line and muffler.
Keep engine below waist level. A hot muffler can cause serious burns.-
Cutting with the line on left side of the shield will throw debris away from the
operator.
TRANSPORTING AND STORAGE
- Allow the engine to cool; secure unit before storing or transporting in
vehicle.- Empty the fuel tank before storing or transporting the unit. Use up
fuel left in the carburetor by starting the engine and letting it run until it
stops.- Store unit and fuel in an area where fuel vapors cannot reach sparks
or open flames from water heaters, electric motors or switches, furnaces,
etc.- Store unit so line limiter cannot accidentally cause injury. Unit can be
hung by the tube.- Store the unit out of the reach of children.If situations
occur which are not covered in this manual, use care and good judgment. If
you need assistance, call 1-800-554-6723.
SPECIAL NOTICE:
This unit is not equipped with a temperature limiting muffler and spark
arresting screen which meets the requirements of California Codes 4442 and
4443. All U.S. forest land and the states of California, Idaho, Maine,
Minnesota, New Jersey, Oregon, and Washington require by law that many
internal combustion engines to be equipped with a spark arrestor screen. If
you operate in a locale where such regulations exist, you are legally
responsible for installing and maintaining the operating condition these parts.
Failure to do so is a violation of the law. If a spark arrestor is required in your
area, contact your Authorized Service Dealer for the proper kit.
SPECIAL NOTICE: