Specifications

5. Start the weed eater by pulling the starter cord. The engine will sound out

of tune and will fail to idle by itself. therefore apply just enough throttle to

keep the engine running.

6. Rotate the LO screw clockwise in one-quarter turn increments checking each

time if the engine is idling smoothly. When you have found the sweet position

do no further adjustments.

Note: For a Video tutorial on how to adjust your Weed Eater Carburetor

please follow this link

Apply full throttle watching the engine. If the engine is sputtering then the

engine is receiving too much fuel from the carburetor. Therefore rotate the HI

screw clockwise in one-quarter turn increments checking each time if the

engine runs smoothly. Again when you find the sweet position do

no further adjustments.

The carburetor is always adjusted near the fuel tank. Before reaching for the

carburetor always ensure that you have enough tools with you so that you can

open up the carburetor. The carburetor is that kind of device that is needed to

take off from the weed wacker because you cannot adjust carburetor by

taking it off from the engine. There are normally told screws used on each side

of the engine. Before reaching for these screws always count the number of

screws so that it would be easier for you to know that how many screws are

there on each side.

One of the most important factors that most of the people don’t bother while

opening or dis-assembling of the devices is that they should handle the screws

with care because once these screws gets lost then there is no chance you can

get your weed wacker engine or the carburetor to be working position again.

Place a screw box near your side and put the entire screws one by ion into

that box. Now as the lightweight weed wackers are now manufactured by

most of the companies so as to make them portable there are some plastic

screws used in the weed wacker covers also.

The screws that are made up of plastic should be opened with the prescribed

tolls and the screws that are made up of metals should be open with the

normal screw drivers. As soon as you have removed the covering of the weed