Specifications

is extremely necessary because it's all about the life of your engine. After you

are sure that you have noted down the fuel to oil mixture ratio for your engine

then the next step would be the amount of the gas and the oil to be mixed.

For example if you are asked to have 30:1 mixture then it means you have to

take 30 parts of the gasoline to mix with the only 1 part of the oil. From this

one can have an idea about the mixture quantity. Don’t even increase the

amount slightly because even a small amount in excess can cause the damage

to the engine parts.

The most common problems that the weed engine company faces is the use

of non-recommended fuels and the oils in the engine. As we all know that

there are lots of other fuel available in the market. These alternative fuels are

good but they are not recommended by the manufacturer companies as the

engines are not designed to manufacture to be run on alternative fuels. For

example if you have bought the weed wacker that works on unleaded

gasoline, then it means that you only have to use gasoline in the engine.

Ethanol is other alternatively used fuel but it is also not recommended by

most of the gas run engines.

Always prefer to use the only recommended fuels in the engine. Now here is

some instruction that you would have to follow to prepare the mixture of the

gas and the oil. As soon as you have purchased the gallon of the

recommended oil you need to have another container in which you have to

prepare the mixture for your weed wacker engine. As soon as to have the

container with you make it sure that the container is completely washed from

inside. Even a small particle of the dust can cause your engine carburetor to

choke. Fill up the required amount of the gasoline into the container and mix

the oil into the container. Shake the container till you feel that the oil is

completely mixed with the gasoline. Now the mixture has been prepared.

Now get the weed wacker that you are using and try to find the cap opening

of the fuel tank of the weed whacker. Make it sure that the weed wacker is

turned off and there is no power supply connected to the weed wacker. There

are some precautionary measure that should be taken so that to avoid any

kind of loss. There is a kit available in the market that is recommended to be

used before the use of the weed wacker. These include the costumes’ and the

tool kit. The tool kit also involves the use of the goggles as they can protect

the eyes from getting damaged. The power source should be out and take the