Specifications

engine should be brought to half position. You have to maintain the throttle as

well.

As the engine starts running smoothly place the weed wacker on to the

direction where you wish to have the weed eaten. There are few other things

that need to be adjusted as well. You have to make it sure that the angle of

the trimmer is so adjusted that it gives the maximum output. In general

practice the trimmer is adjusted thirty degrees. The placements of right and

the left hands are to be adjusted according to the momentum of the engine

and the speed.

For smooth cutting of the grass the throttle needs to be in the constant

position. Never throttle the engine unless until it is in use which means that

while cutting the grass the throttle should be

used. It is highly un-recommended that you

should be using the throttle if the weed wacker is

not in use. Use the wacker with a gentle speed.

Lower the trimmer near the ground from where

you need to cut down the grass. The strings used in the wacker are the ones

that are responsible for cutting.

The use of the electric weed wacker is different from that of gas weed

wackers. There are also some measures to be taken before starting the

electric weed wacker. You need to collect all of the materials needed to start

the electric weed wacker. Before starting to take a look on to the cartridge of

the engine and make it sure it do have the cord placed and if you find that

there is no cord present then you must have to remove the cartridge from the

engine and then put the cartridge into the hole placed at the bottom of the

engine.

There is a weed eater twine that you can see. You just need to place that

twine into the hole of the cartridge. You need to set the wind direction as

well. As soon as you do with the wind direction, make it sure that all of the

parameters are set accordingly. You need to place back the cartridge back to

the original position in order to make it sure that it will work smoothly.

You need to look at the number of filaments that your cartridges have and

then you must also consider the length of your twine as well. If you find it