User Instructions

9
10
1
1
2
Fix the 4 plugs & pins on the car body after the car
body assembled on the chassis.
3
Your remote button also controls your light piping!
A. Press once to turn on solid light will come on.
B. Press twice for quick blinking.
C. Press third for slow blinking
D. Press again to shut o.
PULL IT
BACK
CENTER
PULL IT
FORWARD
PRECAUTIONS AND CARE
ATTACHING SHELL TO CHASSIS
THREADING LIGHT PIPING
SWITCH VEHICLE OFF
WHEN NOT IN USE
Remove 4 pins indicated by red arrows to emove shell Remove Shell to bein threading design
Step 1: Select light pipe
2
Step 2: Select hole on Shell of truck.
From underside of shell insert light thread
and carefully pull through until completely throuh
with connection plugs visible on underside of shell
(body).
Once pulled through weave designs on shell by
weaving in and out from underside of shell to topside
shell until full length of light piping is used.
Remember to leave room for connection plugs to
reach battery cables to power lights.
WIPE CLEAN WITH DRY
SOFT CLOTH OR TOWEL
DO NOT USE CHEICALS OR WATER
WARNING: Small Parts
0-3
Once threaded and connected to battery you are
ready to use your light piping
1X Solid 2X Blinking 3X Blinking