User Instructions
A B
E
DC
Requires 3.7V lithium battery and 2 x AA batteries(not included)
FCC statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Battery warning: batteries are to be inserted with the correct polarity.
Lithium battery statements:
. Battery may explode or leak chemicals if opened, exposed to re or high temperature, installed backwards,
or mixed with other battery types.
Battery warning:
. Do not mix alkaline, standard (carbon-zinc), and rechargeable batteries (Nickel-cadmium).
. Do not mix old and new batteries.
. Non-rechargeable batteries are not to be recharged.
. Rechargeable batteries are to be removed from the unit before being charged (if removable).
. Rechargeable batteries are only to be charged under adult supervision (if removable).
. Exhausted batteries are to be removed.
. The supply terminals are not to be short-circuited.
. Only batteries of the same or equivalent type as recommended are to batteries are to be inserted with the
correct polarity.
Conforms to safety requirements of ASTM, FCC, CPSIA.
Warning: Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Charging the battery
1. Insert the battery charging plug into the USB charger’s socket. The charging plug and the USB charger’s
socket t only one way. Do not force them (see illustration A).
2. Connect the USB end of the cable to your computer's USB port or a USB wall charger (see diagram B),
the red CHARGE indicator light turns to stay to show that charging is in progress.
3. Average charging time is approximately 1.5 hours. The vehicle operates for approximately 25 minutes
on a full charge.
4.The red charging indicator turns o when the battery is fully charged.
Note: periodically examine the charger for external damage. External damage to the charger may result
in the risk of re, electric shock, or injury to persons. Never use a damaged adapter.
Set-up
1. Install the included Lithium battery into the vehicle.
a) Remove the battery compartment cover on the bottom side of the truck (see diagram C ).
b) Connect the rechargeable Lithium battery cord directly to the car’s power cord socket, make sure the
connection is secure. The Lithium battery connecting plug and the car’s socket t in only one direction;
never force connection (see diagram D).
c) Carefully replace the battery compartment.
2. Install batteries into the remote control.
Open the battery cover on the bottom of the remote control (see diagram E).
Insert 2 AA batteries (not included) into the battery compartment, matching polarity (+ and - ) marked
inside. Replace the battery cover.