AGE 8+ DRIFT KING Please read instructions completely before operating this car. ©2021 Distributed by: WeCool Toys, Inc. 801 Arnold Ave. Point Pleasant, NJ 088742 © 2021 WeCool. www.wecooltoys.
GENERAL INFORMATION This user's manual is designed for use with your vehicles and contains the instructions you will need to assemble, operate and maintain your vehicles. GETTING FAMILIARIZED WITH YOUR 2.4GHz RADIO SYSTEM Your car is equipped with the new 2.4GHz radio system. Please read and understand all instructions below before operating. We know you are anxious to start driving , but it is very important that you take time to read the manual even if you are an experience RIC driver.
CHECK STEERING PERFORMANCE TO REVERSE THE STEERING MODE Ensure good steering performance. Steering Reverse: It allows you to electronically switch the direction of steering servo travel. TURN LEFT TURN RIGHT FRONT BACK CENTER FRONT BACK REV 1) To keep the car run straight in line. Do not move the control wheel. (keep it at center) 2) Turn it left to allow your vehicle tum to left. NOR 3) Turn it right to allow your vehicle turn to right.
Requires 3.7V lithium battery and 2 x AA batteries(not included) FCC statement: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Battery warning: batteries are to be inserted with the correct polarity. Charging the battery 1.
TROUBLESHOOTING RUNNING PRACTICE PRACTICE 1. Check to see if transmitter and car are on. A. The vehicle does not work at all. 2. Replace batteries 3. Check if there are damaged parts. 1. Replace or charge the battery pack and/or the radio batteries. B. The vehicle runs slow. Once you become conformable driving the vehicle, perform driving practice on the tracks as shown in the figure. Keep practising until you feel comfortable with the steering, throttle and brake at low speeds.
PRECAUTIONS AND CARE THREADING LIGHT PIPING 1 2 Step 1: Select light pipe Step 2: Select hole on Shell of truck. From underside of shell insert light thread and carefully pull through until completely throuh with connection plugs visible on underside of shell (body). Once pulled through weave designs on shell by weaving in and out from underside of shell to topside shell until full length of light piping is used. Remember to leave room for connection plugs to reach battery cables to power lights.
