User's Manual

Decorative
buttons
Forward
Backward
ON/OFF
(1). Press the buttons as shown on the above
picture to move the vehicle forward or
backward.
(2). Press the left or right button of the
transmitter to make the vehicle turn left or right
respectively.
(3). To make the vehicle flip over, while
pressing the forward buttons together,
quickly press the backward buttons. You
might need to switch the back and forward
buttons depending on which side the vehicle
is running.
(4). In order to perform a 360 degrees spin with
your vehicle, press the simultaneously the
diagonally opposite forward and backward buttons
on the transmitter as shown on the picture above.
(1). Unscrew the back cover of the vehicle and slide it out. Do not throw it away.
(2). Apply three or four velcro pads on the back of the light piping battery pack.
(3). Apply the three or four opposite velcro pads on the back of the vehicles making sure they are
centered and fit the way you sticked them on the battery pack.
(4). Customise your vehicle by placing velcro pads where you want the light to be and do the same on
the light piping.
(5). Make sure to have the whole wire fit the vehicle housing to avoid issues while running your vehicle.
(6). Turn on the light on the battery pack: light on, light off, slow flashing.
(7). When you want to use your vehicle into the water, please remove the charger and the light piping.
WARNING: Please do NOT play in the water while the light piping is on! It MUST be removed before
going into amphibious mode!
We do not take any responsibility for damage that occurs as the result of incorrect operations.
(5). Water might get into your vehicle while playing
the amphibious mode. To remove water, just slide
the lid and pour the water out of the vehicle. Water
in your vehicle will still make it float on the water.
SET UP THE OPTIONAL LIGHT PIPING PACK
Please turn on the switches both on the car and the transmitter to get started.
How to use your remote controller
BASIC OPERATIONS