User Manual

containing chloric annex may damage and crack plastic parts. Do not wipe them with such solvent wipe plastic parts with a soft cloth lightly
dampened with soapy water.
25. Consult an authorized service agent in the event of power tool failure.
26. Use only original. Replacement parts.
27. This tool should only be disassembled for replacement of carbon brushes.
PRECAUTIONS ON USING HAMMER
1. Wear protective glasses to protect your eyes.
2. Wear a mask when turning your head upward.
3. Use earplugs to keep your ears noise-free while working.
4. Properly set the bi holder.
5. Since the bit becomes very hot during operation. Exercise extremes very hot.
6. Be sure to use side handle.
7. Safe operation depends on one’s stable posture.
8. At the start of work. Confirm the oil supply and screw tightenting.
9. When working at a highly elevated location. Pay attention to articles and persons below.
10. Before starting breaking or chipping a wall. Floor or ceiling. Thoroughly confirm that no items such as an electric cable or conduit are buried
inside.
11. Wear protective shoes to protect your feet.
SPECIFICATIONS
Voltage(by areas) 110V -60 Hz
Input 3600W full-load impact rate 1800BPM
Weight (without cord) 14KG
Be sure to check the nameplate on product because it is subject to change by areas.
Due to our company’s continuing program of research and development, the specifications herein are subject to change without prior notice.
STANDARD ACCESSORIES
(1) BMC Case X 1
(2) Point &Flat Chisel (30*390mm) X 2
(3) 5, 6, 8 Socket head wrench X 3
(4) Wrench X 1
(5) Instruction Book x 1
(6) Oilcan x 1
(7) Carbon Brush x 2
(8) Gloves x 1
(9) Glasses x 1
(10) Earplug x 1
(11) Mask x 1
OPTIONAL ACCESSORIES(SOLD SEPARATELY)
Cutter (for crushing asphalt)
1. Power source
2. Grounding
3. Power switch
4. Extension cord
5. Feeding oil
6. Mounting a tool
HOW TO USE THE HAMMER(SEE PICTURE 3)
1. After placing the tip of the tool in the base hold switch ON.
2. By utilizing the weight of the machine and by firmly holding the hammer with both hands. One can effectively control the subsequent recoil
motion.