Brochure

INSTALLATION SOLUTIONS FOR
FLOOR STANDING / TOP MOUNT BOILERS
COMPLETE NEAR
BOILER PIPING KITS
FEATURES:
• Choice of FIP or SWT Hydro-Core Manifold
• Insulated return line assembled from one-
piece, 4 1/2" length type-L copper tubing
• Insulated supply line assembled with
24" length Hydro-Core Flex tubing
• Integrated connections for
your speci c boiler
• Integrated Mesh "Y” Strainer
with Rotating Flange
• Plugged 1 ⁄2" strainer cap port
• Plugged FIP ports
IPS System Piping SWT System Piping
4CF4L-FT144
4CF4R-FT144
4CF5-FT245
4CF5-FT2R45
5CF4L-FT144
5CF4R-FT144
5CF5-FT245
5CF5-FT2R45
COMPATIBLE WITH SELECT BOILERS FROM:*
•BRADFORDWHITE •LAARS •PEERLESS •RAYPAK
•SLANTFIN •TRIANGLETUBE •WEIL-MCLAIN
REMOVE 1"
INSULATION
CUT MUST
BE CENTERED
IN CONVOLUTION
TO CUT TUBING (IF DESIRED)
The amount of Hydro-Core Flex Piping provided is suitable for wide range of boilers.
However, tubing may be cut to suit the needs of your speci c installation if so
desired. Retaining excess length will not effect the performance of the system.
To Cut Hydro-Core Flex Tubing:
1. Remove end connections.
2. Measure the desired pipe length and mark this point on the insulation.
3. Remove the insulation beyond this mark – DO NOT CUT THE TUBING.
4. Measure one inch of exposed pipe above the insulation. This is the cut point.
5. Using a metal tube cutter, cut the tube at the cut point.
Cut MUST be centered in a valley between corrugations.
6. Insert tube into the  tting, then tighten end connections.
For full assembly instructions see www.webstonvalves.com/instructions/
SEE WWW.WEBSTONEVALVES.COM/HYDROCORE FOR A FULL BOILER COMPATIBILITY CHART
* All manufacturer names, models and part numbers are trademarked or registered trademark property of their respective owners. Webstone products are not manufactured, sponsored, authorized, or endorsed by any party unless otherwise noted.
BOILER