User Guide

STEP 1: Mount Outside
Antenna & Route Cable
STEP 2: Connect Cable
To Outside Antenna
STEP 5: Connect Power
Supply To Booster
STEP 4: Booster Location
& Connect Cables
STEP 3: Inside Antenna
Location
Find a location to place the Drive Reach
Booster and secure it with provided bracket.
Connect cable from Outside Antenna to
labeled booster port and connect cable from
Inside Antenna to labeled booster port.
Place Inside Antenna where stronger
signal is desired in the RV.
Determine where you want the Outside
Antenna on your RV. Mount the Outside
Antenna to a ladder or pole so that the
entire Outside Antenna is above the roof
line of the RV. Route 25’ RG-6 cable from
inside RV to Outside Antenna.
NOTE: L-Bracket Pole Mount and
hardware is provided. If installing with
Spring, the Side Exit Adapter must
be used.
Refer to Installation Guide for Detailed Instructions.
®
from Inside
Antenna
from Outside
Antenna
Booster
After routing the RG-6 Cable into the
RV, connect the cable to the
Outside Antenna.
RG-6
Cable
Inside Antenna
common Outside
Antenna mounting
location
Outside Antenna
Side Exit
Adapter
Spring
(optional)
ladder rail
L-Bracket Mount &
hardware
Connect the power supply cord to the
end of the booster, labeled “
”, and
connect into a 110V wall plug. Enjoy your
boosted signal!