Installation Guide

7
VEHICLE SIGNAL BOOSTER DRIVE X
______
Step 5: Connect Power
Supply To Booster
Connect the power supply cord to the end of the booster,
labeled “Power”.
NOTE: Do NOT connect the power to the signal booster until you have
connected both the inside and outside antennas.
Plug the power adapter into vehicle’s 12V DC power supply.
Power up your Drive X by flipping the switch on the back of
the DC power adapter on. If your Drive X is working correctly,
the light on the power adapter will be red, and the light on the
booster will be green.
DC Power
Adapter
Power Supply