A WILSON ELECTRONICS BRAND Office 100 Cell Signal Booster Office 100 Installation Guide NEED HELP? support.weboost.com 866.294.
______ Index Package Contents 1 Preparation 2 STEP 1: Inside Antenna & Booster Placement 4 STEP 2: M ount Outside Antenna 5 STEP 3: Route & Connect Outside Antenna To Booster 6 STEP 4: Route & Connect Inside Antenna To Booster 7 STEP 5: Power Up The Booster 8 Measuring Booster Performance 9 Light Patterns 11 Troubleshooting 12 Safety Guidelines 13 Specifications 15 Warranty 16
______ Package Contents Office 100 50 Ohm Kit Office 100 Booster Power Supply (850030) Inside Antenna (304412) Outside Antenna (314422) Lightning Surge Protector (859902) 75’ & 60’ Wilson 400 Cables (952360 & 952375) 2’ Wilson 400 Cable (952302) Cable Mounting Clips Office 100 75 Ohm Kit Office 100 Booster Power Supply (850030) OFFICE 100 Inside Antenna (304419) Outside Antenna (314423) Lightning Surge Protector (859992) 75’ & 60’ RG-11 Cables (951160 & 951175) 2’ RG-11 Cable (951127) Cabl
______ Preparation You Will Need (tools not included) Make sure the following materials are prepared and ready for your installation.
______ Installation Diagram 60 FEET HORIZONTAL OR 25 FEET VERTICAL DISTANCE Troubleshooting section recommends increasing distance further if needed.
______ Step 1: Inside Antenna & Booster Placement Place the inside antenna in the ceiling over where you need the greatest signal boost and place booster in your desired location at least 24” away from inside antenna. NOTE: Do not connect booster to power until the system is fully installed.
______ Step 2: Mount Outside Antenna Pole mounting and wall mounting options are included. Attach the mount to the outside antenna and use the bracket clamp to attach the antenna to a pole or exhaust pipe. Outside Antenna U-Bolt Pole Bracket existing pole NOTE: Mounting on existing roof exhaust pipe would be a good time-saver option. Watch out for power lines.
______ Step 3: Route & Connect Outside Antenna To Booster Connect 2 ft. coax cable to outside antenna, attach the lightning surge protector, then connect the black 75 ft. coax cable and route into building. Cable Mounting Clips provided Outside Antenna Lightning Surge Protector 75’ Coax Cable 2’ Coax Cable Booster Route cable to the Office 100 booster and connect to the port labeled ‘OUTSIDE ANTENNA’.
______ Step 4: Route & Connect Inside Antenna To Booster Connect the black 60 ft. coax cable to inside antenna and route to the Office 100 booster and connect to the port labeled ‘INSIDE ANTENNA’.
______ Step 5: Power Up The Booster Plug the power supply into wall outlet then connect to end of booster labeled “ ” and enjoy your boosted signal. NOTE: We strongly recommend using a power strip with surge protection. to power 60 FEET HORIZONTAL OR 25 FEET VERTICAL DISTANCE Troubleshooting section recommends increasing distance further if needed.
______ Measuring Booster Performance How To Get Signal Strength As A Number iPhone® iOS 11 and later no longer displays the decibel (dBm) reading in ‘Field Test Mode’. Tip: Using the signal bars and performing data speed tests on your cell phone can assist you in finding the strongest signal direction as well as placing calls in different locations. For changes/updates on this issue, periodically go to weboost.com/signalstrength.
______ (MEASURING BOOSTER PERFORMANCE cont.) Signal Strength without Booster Note here: Signal Strength with Booster Note here: Compare Results Having an accurate measurement of signal strength in decibel-milliwatts (dBm) is crucial when installing your system. dBm accurately measure the signal strength you are receiving.
______ Light Patterns Solid Green Booster lights This indicates that your booster is functioning properly and there are no issues with installation. Office 100 Blinking Green & Red Band has reduced gain. This indicates Band 4 Band 5 Band 12/13/17 that one or more of the booster bands Band 2/25 has reduced gain due to a feedback loop condition called oscillation. This is a built in safety feature to prevent harmful interference with a nearby cell tower.
______ Troubleshooting IF YOU ARE HAPPY WITH THE COVERAGE, THESE LIGHT ISSUES DON’T HAVE TO BE RESOLVED. YOUR CARRIER’S BAND HAS NOT BEEN AFFECTED. FIXING ANY RED LIGHT ISSUES This involves Solid Red & Blinking Green/Red lights. 1 Verify the inside antenna is at least 24” from the booster. Unplug and replug in power supply. 2 Tighten all cable connections (be sure to hand tighten only, do NOT use tools). You may want to undo and redo the connection completely. Unplug and replug in power supply.
______ Safety Guidelines Use only the power supply provided in this package. Use of a non-weBoost power supply may damage your equipment. The signal booster unit is designed for use in an indoor, temperature-controlled environment (less than 100 degrees Fahrenheit). It is not intended for use in attics or similar locations subject to temperatures in excess of that range. RF Safety Warning: Any antenna used with this device must be located at least 8 inches from all persons.
______ Antenna Kit Options The following accessories are certified by the FCC to be used with the Office 100 Booster. BAND 12/17 BAND 13 BAND 5 BAND 4 BAND 25/2 Outside antenna maximum permissible antenna gain (dBi) 50Ω 4.4 4.2 3.9 4.4 4.6 Inside antenna maximum permissible antenna gain (dBi) 50Ω 3.2 3.0 3.2 2.4 2.
______ Specifications Office 100™ Model Number 460060 FCC ID PWO460060 Connectors N-Female or F-Female Antenna Impedance 50 Ohms or 75 Ohms Frequency 698-716 MHz, 729-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz Power output for single cell phone (Uplink) dBm Power output for single cell phone (Downlink) dBm Noise Figure Isolation Power Requirements 700 MHz Band12/17 700 MHz Band13 800 MHz Band 5 1700 MHz Band 4 25.6 25.2 25.8 25.2 1900 MHz Band 25/2 25.
3 YEAR WARRANTY weBoost Signal Boosters are warranted for three (3) years against defects in workmanship and/or materials. Warranty cases may be resolved by returning the product directly to the reseller with a dated proof of purchase. Signal Boosters may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material Authorization (RMA) number supplied by weBoost. weBoost shall, at its option, either repair or replace the product.
Notes NEED HELP? OFFICE 100 support.weboost.com CELL PHONE SIGNAL BOOSTER 866.294.
3301 East Deseret Drive, St. George, UT 866.294.1660 www.weboost.com support.weboost.com Copyright © 2021 weBoost. All rights reserved. weBoost products covered by U.S. patent(s) and pending application(s) For patents go to: weboost.com/us/patents NOT AFFILIATED WITH WILSON ANTENNA GDE000417_Rev01_05.17.
