User Manual

5
ENGLISH
Need help? www.weboost.com Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm
Installation Options
In-Building Installation Option
1. Install the antenna to a window. These
instructions are for use with the weBoost
Magnet-Mount or Mini-Magnet Mount
Antenna. If you purchased a different
antenna separately, follow the instructions
included with that antenna.
• Select a window on the side of the building
where you get the strongest cell signal. You
can determine the strongest signal area by
walking around the building and checking
the bars on your mobile phone. You should
wait 30 seconds for new signal strength
to register. For a more accurate method
of determining signal strength, read the
instructions at http://www.weboost.com/us/
test-mode-instructions.
WAIT 30
SECONDS
• Clean a spot as high on the designated
window as possible with the alcohol prep pad.
Attach the suction cup bracket to the cleaned spot
on the inside of the window.
NOTE: Many newer energy efcient windows use
a metal coating that may decrease the strength of
a cellular signal, reducing the effectiveness of the
Drive 3G-Flex. If you have dual pane windows,
consider a weBoost signal boost product that
provides an option for mounting an antenna on an
outside wall or roof of a building.
• With the bracket in place, attach the
magnet base of the antenna to the at
surface of the bracket. The antenna must
be mounted vertically for the best signal.
2. Attach the antenna to the Drive 3G-Flex
signal booster. Connect the cable from the
antenna to the connector on the bottom
of the signal booster. Do NOT plug in the
power supply (step 4) until the antenna
cable is connected to the Drive 3G-Flex
signal booster.
3. Place the Drive 3G-Flex signal booster in
a convenient location close to your cellular
device. This can be on a desk, a tabletop,
a shelf, or the optional desktop mount (sold
separately). The Drive 3G-Flex works best
when within three feet of your mobile device.
WORKS BEST
WHEN WITHIN
3 FEET
4. Connect the Drive 3G-Flex to a power
supply. Attach the AC power cord to the
mini-USB port on the bottom of the signal
booster. Plug the AC power cord into a
surge protected power strip.