User Manual

3
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com Hours: 7am to 6pm MST.
4
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com Hours: 7am to 6pm MST.
Wall Mount InstallationCeiling Mount Installation
Find the desired location for the Panel Antenna. Verify that the Panel
Antenna and the Outside Antenna have the necessary separation (see
Signal Booster instructions for requirements).
For optimum results, the antenna should be mounted a minimum of 6
feet from the fl oor.
Utilize Wall Mount Bracket (see diagram below) as your template. Drill
out the four holes for the screws in the wall, using a 3/16 size drill bit,
following your template. Tap in wall anchors provided and place the
mounting bracket over the wall anchors, insert the screws and tighten.
Slide the Panel Antenna onto the wall mount bracket (see diagram
below).
Wide-Band Panel Antenna
with Ceiling Mount
anchor
slide into
mount
drywall
anchor
anchor &
screw
anchor &
screw
drill 5/8”
hole in ceiling
for end connector
anchor
Select a location on the ceiling that you can access from above to
run the antenna cable. Verify that your chosen location allows for
the necessary separation between the Inside and Outside Antenna
(see Signal Booster installation instructions for antenna separation
requirements).
Use the antenna as your template in your predetermined location.
Note: Ensure that the cable connector location is NOT below a ceiling
rafter.
Drill a hole large enough to accommodate the dimension of the
connector on the location you have marked for the cable. Hold the
antenna to the ceiling and mark the locations for the screws and then
drill a 3/16” hole and tap anchors into the pre-drilled screw holes.
Attach the Signal Booster “Inside Antenna” cable to the connector on the
Ceiling Mount Antenna. Place the antenna fl ush against the ceiling, and
then screw the antenna into place (screws and anchors provided). Be
careful not to over-tighten.
If you have any questions about the installation procedure, please
contact our Technical Support Team toll free at 866-294-1660 or email
tech@wilsonelectronics.com.
Wide-Band
Panel Antenna
Wall Mount
& hardware