Owner's Manual

ENSURE AT THIS STAGE THAT THE BODY END PLUG, ETC. IS FITTED
BEFORE PROCEEDING WITH REFITTING THE TRIGGER ASSEMBLY
Insert the trigger adjusting spring into its pocket in the underside of the body end
plug, then place the trigger in position and fit the remaining fulcrum pin, aligning
first the safe then the trigger. Having inserted the pin right through, fit its circlip.
Check that the action functions satisfactorily before re-assembly into the stock.
Xocet Sear/ Trigger Mechanism.
Locate the sear spring onto the RH side of the sear, i.e. its cranked end
inserted through the small hole in the sear and its central hole aligned with the sear
fulcrum pin hole. Feed this sub - assembly into its correct position in the housing,
lining up the fulcrum hole in the sear with its related hole in the housing. Insert the
sear fulcrum pin (2412) from the left hand side, push right through then fit its
circlip. Insert the front fulcrum pin which acts as a stop for the sear and fit its
circlip. It will be necessary to hold the sear against its pressure to avoid blocking
the hole when inserting the front fulcrum pin.
ENSURE AT THIS STAGE THAT THE BODY END PLUG, ETC. IS FITTED
BEFORE PROCEEDING WITH REFITTING THE TRIGGER ASSEMBLY.
Insert the trigger adjusting spring into its pocket in the underside of the
body end plug Then place the trigger assembly in correct alignment in the housing,
either pushing or holding the long leg of the sear spring out of the way, towards
the body tube. Fit the remaining fulcrum pin and its circlip. Flip the long leg of the
sear spring to lie against the fulcrum pin.
Check that the action functions satisfactorily before re-assembly into the stock.