Owner's Manual

Place the middle finger of the left hand supporting the rifle to the open side of the
magazine Pull the magazine axis pin open with the right hand – the magazine will be
ejected from its barrel housing slot against the left hand finger. The magazine can then
be removed from the barrel housing.
Load the pellets through the rear of the magazine. Push the pellet noses through the
retaining ‘O’ ring until their skirts lie flush or below the bottom of the magazine face.
Once reloaded, refit the magazine to the rifle and retain it with the magazine axis pin. If
necessary, rotate the magazine counter-clockwise until its movement is arrested by the
magazine stop.
DO NOT CLOSE THE BOLT UNTIL YOU ARE READY TO USE THE RIFLE.
ENSURE THE BOLT IS FULLY CLOSED BEFORE FIRING THE RIFLE AS
ITS PERFORMANCE WILL BE AFFECTED IF NOT FULLY CLOSED.
To reload the rifle, pull the bolt fully open before pushing it forwards - this ensures the
sear engages with the hammer assembly and the magazine has indexed to the next
pellet chamber. Once the bolt is closed the rifle is ready to fire.
As the pellets are used and the magazine rotates, its empty chambers become visible
above the barrel housing. These chambers may be refilled as they are revealed without
removing the magazine if desired.
NOTE
Do not cycle the bolt until the pellet in the barrel chamber has been fired.
Reloading the rifle continually without firing will push another pellet/pellets into
the barrel bore. This action will block the barrel and it will be necessary to
dismantle the barrel from the rifle to remove the blockage.
If the magazine is unintentionally indexed, adopt either of the following procedures to
prevent another pellet from entering the barrel chamber:
a) With the bolt fully open, rotate the magazine clockwise by hand
until the empty chamber is back in line with the barrel, then close
the bolt.
b) Remove the magazine from the rifle, close the bolt, point the rifle at
a target, then fire the rifle. Refill the magazine and refit to the rifle.
SAFETY.
In the interest of safety, never store or leave the rifle unattended with pellets left in the
magazine or barrel chamber. To make a loaded rifle safe, open the bolt and remove the
magazine. If a pellet has been loaded into the barrel, close the bolt, point the gun at a
safe target and fire the rifle.
If desired, refit the empty magazine to the rifle, hold the bolt handle in the most rearward
position against the hammer spring pressure, then pull the trigger. Allow the hammer
spring pressure to slowly close the bolt assembly. Alternatively, close the bolt, point the
rifle towards a safe target and fire the rifle.
It is recommended to store the magazines separately from the rifle to prevent
unwarranted use
2