Owner's Manual

Before using your new rifle:
1. Check it is fully charged.
2. Fit your optional `scope and mounts.
3. Appreciate the basic safety rules.
THE BASIC SAFETY RULES ARE:
1. Treat every rifle as if it is loaded.
2. Never point the rifle at anyone, or allow anyone to point a rifle
at you, even if you know it is not loaded.
3. Always carry the rifle so that the direction of the muzzle is
under control, even if you stumble.
4. Always be sure of your target and what lies behind it before
firing your rifle.
5. Never leave a loaded rifle unattended.
6. Beware of targets that tend to cause ricochets.
OPERATING INSTRUCTIONS.
CHARGING THE RIFLE.
Fit the filler nozzle to the air-line of the charging equipment, which must incorporate a
pressure gauge. Remove the filler hole plug from the front of the rifle. Ensure both filler
nozzle and rifle filler hole are clear from dirt and push the nozzle into the filler hole. Fill
the rifle to the cylinder pressure quoted previously in this manual. Do not exceed the
maximum fill pressure as this will reduce the velocity of the rifle and may damage rifle
components. When using a divers bottle, refill the rifle slowly to prevent the heat created
by the filling operation damaging the rifles components.
Undo the hose air drain screw
before pulling the filler nozzle out of the rifle. Refit the filler hole plug to the rifle.
LOADING THE RIFLE AND USING THE MAGAZINE.
LOADING THE MAGAZINE.
The magazine incorporates a raised boss on its rear face and can only be fitted one way
to the rifle. It rotates clockwise when viewed from the rear of the rifle. The groove on the
side of the barrel housing allows you to observe whether the next magazine chamber
about to rotate into alignment with the barrel is loaded with a pellet or empty.
To remove the magazine, open the bolt and push it into the rear cylinder tube slot (safe
position). THIS OPERATION COCKS THE TRIGGER MECHANISM / HAMMER
ASSEMBLY. IF THE BOLT IS NOT IN THE SAFE POSITION AND THE TRIGGER IS
PULLED, THE RIFLE WILL DISCHARGE.
4