Instruction Manual

Grip frame adjustment
Your air-gun has a adjustable palm shelf
allowingyoutosetthegriptotyour
hand.
Loosen the screws shown in Fig. 15 using
the special tool supplied and adjust it
bymovingupwardanddownwardtot
the size of your hand. Tighten the screws
whenyouhavethecorrectt.
Looking after your Webley Alecto™
MAINTENANCE
Each and every Webley Alecto™ Air -Pistol is built to provide a lifetime of high
performance service and requires very little in the way of user maintenance
other than all Metal components must be wiped over regularly with lint free cloth
impregnated with synthetic oil such
aslogunSL7tohelpresistcorrosion.
(Do not lubricate plastic components).
After every 1000 shots or every 6 months
even if the air-pistol is not in use, add the
supplied mineral solvent based oil (less
than 0.5 ml.), using the hole as shown in
Fig. 16. After lubrication, if you intend to
store the air-pistol after oiling, cock and
rethepistolwithoutloadinganypellets
for at least twenty shots and then store
in its original packaging.
Itisvitalthattheair-pistolisneverdismantledormodicationsmadeotherthan
byWebleytrainedtechnicians.Suchactionswillbehighlightedtoourtechnicians
through the examination of anti tampering devices built into the pistol. If any such
evidence manifests itself, the pistols warranty will be invalidated.
Adjustment of the sights
CAUTION!
The speed of pellets varies according to type, brand and weight of the pellets used.
Choose a brand and type of pellets you will use on a continuous basis, and make
your adjustments according to that brand of pellets. Webley recommends the use
of Accupell ™ pellets for optimum performance and accuracy,as the Alecto™ was
developed using this ammunition and is optimized for it
ADJUSTMENT OF FRONT SIGHT
The front sight has two positions.
By rotating the full front sight by
90° the adjust the range at which
you are shoot from 10m to 25m
without adjusting the rear sight as
shown in Fig. 11 – 12
These measurements of the
front sight are an approximate
estimate, and the actual values
may differ.
ADJUSTMENT OF REAR SIGHT
WINDAGE
ADJUSTMENT
Turning the screw
clockwise as shown in
Fig 13 will send the point
of impact to the right.
Turning the screw anti-
clockwise in Fig 13 will
send the point of impact
to the left.
VERTICAL ADJUSTMENT
Turning the screw in Fig 14 clockwise will lower point of impact. Turning the screw
in Fig 14 anti-clockwise will raise the point of impact. Do not raise the vertical screw
too high.
0706
Fig.11 Fig.12
Fig.16
Fig.15
Fig.13 Fig.14