Instruction Manual

Trigger settings
CAUTION!
Do not load the air-pistol with pellets whilst setting the trigger adjustments.
Always point the air-pistol in a safe direction whilst setting the trigger.
Always check your adjustments by cocking the air-pistol to the maximum 3 times
as the trigger setting vary slightly for the different power levels.
Fig.7 Fig.8 Fig.9
1. Trigger right & left adjustment
When the screw shown in Fig.7 s loosened, the trigger can be turned to the right
& left side, or slid downwards up to 2 mm. When you have your desired position
re-tighten the screw.
2. Trigger forward & backward adjustment
When the screw shown in Fig.8 is loosened, the trigger can slide forward &
backward up to 7 mm. You must then re-tighten the screw.
3. Trigger spring strength adjustment
To increase the trigger load turn the screw shown in Fig.9 turn clockwise
using the supplied tool. To decrease the trigger load turn the screw shown in
Fig.9 anticlockwise. This will vary the load from 0.4 kg ( 0.9 lbs) to 1.8 kg ( 4 lbs).
CAUTION!
Default setting for the spring strength is at the lowest.
4. Length of trigger pull
To adjust the length of the trigger pull turn the
screw
Fig.10 clockwise to decrease the length and anti-
clockwise to increase the length of trigger pull
CAUTION! Fig.10
Do not reduce the length of trigger pull below the factory setting as the air-pistol will
dis-charge whilst closing the action.
Donotincreasethelengthoftriggerpullexcessivelyastheair-pistolwillnotreand
eventually the mechanism will disengage and the air-pistol will be inoperable.
Loading the Webley Alecto ™Air-Pistol
Hold the grip with your right hand and the upper cover with your left hand Fig. 1-2.
Lift the levers indicated on Fig.1 and completely open the upper cover Fig.3.
Fig.1 Fig.2 Fig.3
CAUTION!
If you fail to open the upper cover completely the velocity of the pellet will be affected.
Insert a pellet into the breech end of the barrel until the back of the pellet is flush
with end of the barrel Fig.4.
CAUTION!
If the back of the pellet is not flush with end of the barrel the joint seal will be
damaged and the performance of the pistol will be affected.
Close the barrel housing with a circular movement until it engages with the catches Fig.
Fig.4 Fig.5 Fig.6
CAUTION!
Whenloadingthepistolkeepyourngerawayfromthetrigger.
Duringtheclosingaction,nevercloseyourngersaroundtheuppercoverasshowninFig.
6.Avoidpinchingyourngersorclothesbetweentheuppercoverandthebottomfame
If you require extra power, the cocking procedure can be carried out up to a
maximum of 3 times, Extra cocking strokes, beyond three, will not increase power
but will eventually damage the internals of the pistol.
Do not load the pellet until the last cocking stroke as the pellet will drop out of the
barrel as the pistol is opened.
Do not load more than one pellet per shot.
Takeaimatasafetarget,pushthesafetyforwardintoreposition.Thegunisnow
readytore
0504