User`s guide

WebEye E10/E104WebEye E10/E104 User’s Guide
46
11) Digital I/O Configuration
This page is to configure digital
input/output states and control script.
WebEye sends e-mails or/and files
when connected external sensors detect
events.
(1) Device Type for Input Port 1 & 2
Administrator defines active state of 2
digital devices connected to two input
ports such as infrared sensors. If you connect normal open type device to input port, you should
select ‘NO (Normal Open)’. With normal close type device, you should select ‘NC (Normal
Close)’.
(2) Current State for Input Port 1 and 2:
WebEye shows current states of the 2 digital devices connected to 2 input ports. In the status panel,
active state or de-active state message shows. ‘De-Active State’ means that connected device didn’t
detect any event when ‘Apply button’ is clicked. Though this message is not updated until you click
‘Confirm’ button again, WebEye keeps on receiving status information from the connected device.
(3) Active State for Output Prot 1
Administrator defines active state of a digital device to be connected to the output ports such as an
electronic locker or a switch. Active states of digital devices may differ depending on items or
models (select between ‘Open’ or ‘Close’)
(4) Current State for Output Port 1
According to active state definition, WebEye shows current states of the digital device connected to
an output port. Its state is defined at ‘Active State for Output Port’ menu.
(5) Status Control for Output Port1
Administrator controls an external device that is connected to the output port. After defining active
state of the device at ‘Active State for Output Port 1’, Administrator controls the device to act or not
with this menu.
(6) Active Condition and Duration for Output Port1
Administrator defines active conditions for an external device such as an electric light that is
connected to the output port. After defining active state and controlling status of the device,
administrator defines active conditions among internal S/W motion detection (MD Event) and two
external sensors (SID1 & SID2 Event). And ‘Active Duration’ menu is to set the period of time to
activate the external device after detecting event. If the event lasts long, WebEye activate the device
for preset time after the last event detection.